Name: t.a.c. I/A MicroNet MN-S3
Brand: t.a.c.
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Figure-8 Electronic Assembly Installation.

3. Insert bottom tabs of cover and then snap top into place.

Note:

To remove sensor cover, place thumb in middle of sensor, grasp top edge of cover

with fingers and pull firmly.

Electronic

assembly

Questions and Answers:

Need help?

Do you have a question about the t.a.c. I/A MicroNet MN-S3 and is the answer not in the manual?

t.a.c. I/A MicroNet MN-S3 Specifications

General