11
ENGLISH
WARNING! The drip tray must be positioned on a level
surface and must not jut out from the surface it is resting
on.
Control Panel
Your appliance features a display providing you with
important and useful information.
Two LEDs on the top of the lid provide important
indications:
Green (ON/OFF) LED on the left of the panel: when lit, it
indicates that the appliance is operating.
Green beer-temperature LED on the right side of the
panel: when the DraughtKeg
TM
has reached the ideal
temperature the LED switches on and the appliance
goes into “stand-by” cooling mode.
Warning: never use your BeerTender® with ambient
temperature above 86°F. Above that level, the ideal
serving temperature can not be attained.
Pouring a beer from the BeerTender
* Before pouring a beer, rinse a clean glass in cold
water which chills the glass and wets the inside to
enable a perfectly smooth draught pour. Use of 8 oz
glasses is recommended to maintain the ideal serving
temperature.
Draught and Drink
* Be aware that the first glass you pour from every new
DraughtKeg will contain mostly foam. This is typical of
draught beer. Allow the foam to settle and continue to
pour.
* Tilt and pour: Tilt your glass at a 45 degree angle as
you pour and adjust upright as the glass fills.
* Ensure you pull the tap handle all the way down. Not
opening the handle all the way will result in excessive
foam.
* For the optimal draught beer drinking experience,
serve your beer with a foam head of 2 fingers in height
(approximately 1.5”).
To Next Page
Loading...
