10
ENGLISH
* After setting up the BeerTender® and before use, it is
vital to clean the detachable pour spout – this is the
only part of the appliance that will come into contact
with the beer. The spout should be rinsed by hand.
After cleaning, screw back into place.
* Before inserting the DraughtKeg
TM
into the
BeerTender, simply snap the patented disposable
draught beer tube (5 tubes included) onto the
DraughtKeg.
* Open the BeerTender cover by pressing in the release
panel on the top of the machine.
* Place DraughtKeg into BeerTender.
* Remove the tap spout cover by lifting it up.
* Position the draught beer tube as shown in drawing.
* Put the tap spout cover back into place.
* Carefully close the lid.
* Set the drip tray and grate in place at the front of the
appliance. Make sure the drip tray is properly fitted
and positioned.
To Next Page
Loading...
