What to do if my T.I.P. Lighting Equipment pump stops after a short time?
If your T.I.P. Lighting Equipment pump stops shortly after starting due to the thermal motor protection, verify that the electrical supply matches the type plate information using a GS-compliant device. Also, remove any blockages from the pump or intake openings. Ensure the liquid temperature isn't too high and eliminate any causes of the pump running dry.
What to do if my T.I.P. SPF 370 F motor is running but not pumping water?
If your T.I.P. Lighting Equipment pump isn't discharging liquid and the motor is running, first, make sure the pump housing is filled with liquid by ensuring the water level in the pool is above the pump's suction point and the strainer is free of dirt. Then, check for air leaks by ensuring intake line connections are tight and that there are no siphons, kinks, counter-slopes, or narrow spots in the intake lines. Finally, inspect the check valve for blockages or damage and clean the pump insert, checking the impeller for blockages.
How to fix a noisy T.I.P. SPF 370 F Lighting Equipment pump?
If there is noise in the T.I.P. Lighting Equipment pump during operation, check and clean the suction hose for any blockage during aspiration. Improve the suction inlet by ensuring it is under the water level of the swimming pool, reduce the number of screws, and assemble a pipe with a larger diameter. If air penetrates the intake line, refer to section 2 of this table. For defect bearings or faults in the impeller, contact your local service partner or the manufacturer.
General safety information and precautions for the use of the swimming pool filter set.
Explanation of how the sand filter set operates to clean pool water.
General instructions and precautions for installing the pump and filter system.
Step-by-step guide for mounting the pump and sand filter components.
Instructions for connecting the pump's inlet and outlet hoses correctly.
Guidelines for the fixed installation of the pump and electrical connections.
Important notes and precautions before starting the pump for the first time.
Explanation of the functions of the 4-position valve for filter operation.
General| Brand | T.I.P. |
|---|---|
| Model | SPF 370 F |
| Category | Lighting Equipment |
| Language | English |
To Next Page