57
Machines with swivel
hitch
Machines with wide angle
shaft standard drawbar
Every 10 hours (d
a
ily)
Every 20 hours
Every 40 hours
Number of lubrication points
XX
4
Connection arms
XX
4
Wheel bracket, lifting cylinder
XX
*)
2
Rotor
XX
2
Splined pin below gearbox
XX
*)
2
Universal joint
XX
1
Tension roller
XX
2
Spring guide
Movable mechanical joints should be lubricated as required and the wheel hubs should be refilled
with grease once per season.
During idle periods (one week or more): Wash and lubricate the machine, spray it with a thin
layer of rust protecting oil - this is especially important for cutting discs, rotor and all shining
surfaces.
*) Lubrication of these nipples can only be carried out when the cutterbar of the machine is in the
"oil check position" - see illustration 1 page 58.
1
2
3
4
5
6
7
To Next Page
Loading...