Need help?Do you have a question about the TacT Audio M2150 and is the answer not in the manual?
General| Brand | TacT Audio |
|---|---|
| Model | M2150 |
| Category | Amplifier |
| Language | English |
Important warnings regarding fire and electric shock risks, advising against exposure to moisture.
Instructions to prevent electrical shock by not removing the cover and referring servicing to qualified personnel.
Detailed instructions for safe installation, operation, and handling of the amplifier, including electrical safety.
Guidance on verifying and matching the unit's operating voltage to the country's supply before connecting power.
Details the five available digital input types: RCA (S/PDIF), AES/EBU (XLR), and TosLink (S/PDIF).
Describes the three stereo analog inputs (RCA, XLR) available when the optional ADC module is installed.
Details the two RS232 ports (INPUT and AUX) used for communication with controllers or other amplifiers.
Instructions for connecting the AC mains power, with a caution to use the correct IEC or grounded cable.
Details the WBT speaker terminals, their compatibility with plugs, and correct polarity connection for positive and negative terminals.
Explains how to configure multiple amplifiers for bi-amping or tri-amping, driving specific speaker drivers or frequency regions.
Describes the ON/OFF, DIGITAL, and ANALOG buttons for controlling power and selecting input sources.
Explains how to adjust the master volume using the control wheel and engage the mute function.
Detailed explanation of each numbered button on the remote control and its specific function.
Details STANDBY, DIGITAL, ANALOG, MENU, and navigation buttons for unit control and menu access.
Explains the VOLUME block buttons for adjusting master volume and engaging the mute function.
Instructions on how to enter the main menu using the MENU button and navigate using directional buttons.
Details how to adjust time alignment by independently controlling delay times for left and right audio outputs.
Explains how to balance channels by adjusting attenuation for left and right output signals.
Details the RMS power output for 8 ohm and 4 ohm loads, and peak output current per channel.
To Next Page
