TACT Millennium MKII - Safety Instructions

Safety Instructions
AII
terminals
are hot
C(
CAUTION:
TO REDUCE THE RISK
OF ELECTRICAL
SHOCK, DO
NOT REMOVE
COVER. NO USER-SERVICEABLE
PARTS INSIDE.
REFER
SERVICING TO AN AUTHORIZED
TACT DEALER.
WARNING: TO REDUCE THE RISK
OF FIRE
OR ELECTRIC
SHOCK. DO
NOT EXPOSE
THIS APPLIANCE TO RAIN
OR MOISTURE.
This
equipment
generates,
uses and can
radiate radio
frequency
energy and, if not installed and
used
in
accordance
with the
instruc-
tions, may
cause
harmful interference
to radio
communications.
Howeve7
there
is
no
guarantee
that interference
will not
occur in a
pa
rticu I
a
r i nsta I I
ati on.
This
can be determined by turning
the equipment
on and off,
the
user is encouraged to
try
to
correct the interference
by one
or more
of
the
following
measures:
.
Reorient or relocate
the
receiving
antenna.
.
lncrease
the separation
between the equipment
and the receiver.
.
Connect the equipment into
an outlet on a
circuit different
from
that to which
the receiver
is
connected.
.
Consult the dealer or an
experienced radiolW
technician for
heln.
CAUTION:
.
Changes
or
modifications
to this equipment
not
expressly
approved
by the manufacturer
could
void
the
user's authority
to
operate the
equipment.
.
Power
is only
completely
removed
from
the circuitry when
the IEC
power
cable is disconnected from
the Millennium. ln
Standby mode
the standby
circuitry
is
powered
.
The
speaker outputs
are
balanced,
all terminals
are hot and
should never
be shorted to the chassrs
or other
speakerposrs.
.
No
bridge coupling is
possible.
lmportant
Symbols
.
The lightning flash
with arrowhead
symbol, within
an equilateral
triangle, is intended
to alert
the
user
to the
presence
of uninsulated
"dangerous
voltage"
within the
product's
enclosure that may
be of
sufficient magnitude
to constitute a risk
of electric shock
to
persons.
.
The
exclamation
point
within
an equilateral
triangle is intended
to
alert the user
to the
presence
of important
operating and mainte-
nance
6erui.c.ing)
instructions in the literature
accompanying
the
appliance.
"'
.
Marking by
the
"CE"
symbol
(shown
left) indicates
compliance of
this device with the EMC
(Electromagnetic
Compatibility)
and LVD
(Low
Voltage Directive)
standards of the European
Community.
TACT Mittennium
.
Owners
Manual
3