Tactic DRONEVIEW - Tactic Droneview Troubleshooting; Resolving File and Connection Issues

TROUBLESHOOTING
PROBLEM: There are missing or corrupt  les on the
memory card.
SOLUTION: 1) Refer to Camera Controls section for
information regarding camera initialization and closing of
 les. 2) The battery voltage may be getting too low for
the camera to operate properly. Stop recording when the
camera has been running for more than 40 minutes. 3)
Allow 5 seconds between taking pictures.
PROBLEM: The Wi-Fi connection is lost while recording.
SOLUTION: 1) There may be interference in the area. Try
operating in a different location. 2) The camera may be
too close to the mobile device. Try to keep it at least 12
inches from the camera. 3) You are exceeding the Wi-Fi
range of the DroneView camera. If possible, maintain a
closer proximity to your device.
PROBLEM: The app does not re-establish connection
after the connection has been lost.
SOLUTION: 1) Open the Wi-Fi settings and manually
connect to the Droneview network. 2) Close the
DroneView app and remove it from the background tasks.
Restart the DroneView app.
PROBLEM: Exporting  les was interrupted and the export
function cannot be restarted.
SOLUTION: Close the DroneView app and remove it from
the background tasks. Restart the DroneView app and run
the export function again.