CHARGE THE CAMERA BATTERY
1. Connect the included USB charge cable to a computer’s
USB Port or to an AC to USB adapter.
2. Connect the LiPo battery to the jack on the opposite
end of the charger.
3. The Battery Charge Meter LEDs will start ashing to
indicate that the charge cycle has started.
4. When the battery is charged, the Battery Charge Meter
LEDs will stop ashing and remain on.
5 The battery will recharge in about 50 minutes if the
camera is turned off and will operate the camera
for about the same time. The USB charge cable can
be used while the camera is operating to extend the
camera’s run time.
To Next Page
Loading...
Need help?
General