2
(1) FPV-RM2 monitor
(1) Sun shield
(1) RP-SMA mast antenna
Carefully thread the included antenna onto the RP-SMA receptacle on the monitor. Do not cross-thread or
overtighten! Mount the antenna before applying power to the monitor.
This monitor has a micro USB charge port on the right side of the monitor to charge the internal battery. A
micro-USB cable and an AC to USB adapter (not included) will be needed. Connecting the cable will start
the charge process, as indicated by the glowing red LED which will turn off when charge is complete. For
best results, use a 1 amp or larger adapter. The typical charge time will be around 3 hours.
WARNING! Charging lithium-polymer batteries poses a risk of FIRE! Follow all care and handling
instructions in this manual to avoid severe and permanent damage to the batteries and all
surroundings which could result quickly from improper use and function.
CONTENTS
ANTENNA INSTALLATION
BATTERY CHARGING
To Next Page
Loading...
General