What to do if the Tadano RCS-FT1 Remote Control crane stops with a two-tone sound?
If the Tadano Remote Control crane stops with a two-tone sound, ensure that the cables of the reception unit or control unit are properly connected. If the issue persists, further guidance can be found on the next page.
What to do if my Tadano RCS-FT1 transmitter turns off by itself?
If the power of the Tadano Remote Control transmitter turns off spontaneously, turn the power on again.
What to do if my Tadano Remote Control turns off during radio-control operation?
If the power of your Tadano Remote Control turns off during operation, ensure that the motion selection switches are returned to the neutral positions, and then turn the power on again.
What to do if my Tadano RCS-FT1 Remote Control is affected by radio wave interference?
If the Tadano Remote Control operation is made in a place with an intensive radio wave interference, approach the transmitter to the reception unit and operate the transmitter.
How to fix Tadano RCS-FT1 Remote Control when lifting metal cargo?
If a large metal cargo is lifted with the crane, or there are obstacles between the transmitter and reception unit, move to a location where the reception unit can be seen and then operate the Tadano Remote Control transmitter. Metal products between the transmitter and reception unit hinder the radio wave transmission.
What to do if the Tadano RCS-FT1 Remote Control accelerator cannot be revved up?
If the accelerator of your Tadano Remote Control cannot be revved up, change to the medium-speed or high-speed mode.
How to prevent interference with Tadano RCS-FT1 from noise sources?
If the Tadano Remote Control operation is made near a noise-generating source, turn off the noise-generating device when possible.
How to fix a Tadano RCS-FT1 when the power LED doesn't light up?
If the power LED does not light up on your Tadano Remote Control, insert batteries, ensure they are inserted correctly, or replace them.
What does it mean when four LEDs flash on my Tadano RCS-FT1 Remote Control?
If four LEDs flash after turning on the power of your Tadano Remote Control, release your finger from the switch or the speed control lever before turning on the power.
Details the components and functions of the transmitter and communication unit.
How to activate and release the emergency stop function.
Troubleshooting and actions when radio control fails.
Procedures for stowing the crane if radio control is not functional.
General| Brand | Tadano |
|---|---|
| Model | RCS-FT1 |
| Category | Remote Control |
| Language | English |
To Next Page
