STEP 3: Clip the two rear brass clips to
the daisy chain directly opposite one
another and slightly behind the seat
cushion. Next count out 11 daisy chain
loops and clip in the front two brass
clips to the daisy chain. When installed
the two front straps should be attached
to the Daisy Chain System
approximately 6 inches in front of the
seat cushion and the two back straps
should be slightly behind the seat
cushion.
STEP 4: Hold the seat-back upright
and tighten down the rear straps by
pulling down on the webbing straps.
Now sit in the seat and tighten the front
two straps by pulling them forwards and
down. Re-adjust rear straps as needed
to ensure the seat back is solidly in
place. The seat will stay upright and
rigid when properly positioned. Use the
elastic bands to secure excess
webbing.
To Next Page
Loading...