Installing the Footrest:
STEP 1: Sit in the seat
and place the footrest in
front of you in a position
with your knees bent
similar to this image.
STEP 2: Thread the footrest webbing through the Daisy Chain at the appropriate
locations and center the footrest from side to side on the board. Use the board graphics
and or count the number of loops from the seat clips to make sure the installation is
even from side to side. Ensure the webbing is not twisted.
STEP 3: Thread the webbing through
the slide-buckles and pull tight, again
checking to ensure the footrest is
centered from side to side on the
board. Use the small elastic band to
secure excess webbing.
To Next Page
Loading...