Sec 3.6
DEFLATING AND RE-PACKING YOUR BOARD
Boards may be left inflated in between uses and can be transported on a vehicle using
approved canoe/kayak tie-down straps and racks. Remember that if your board is left in
the sun and hot weather the pressure inside the board can increase. If this is a
possibility we recommend deflating your board by 2-5psi when not on the water.
Boards can also be deflated and transported inside a vehicle.
DO NOT USE VALVE WRENCH TO UNSCREW VALVE FOR DEFLATION!
STEP 1: To deflate, open the valve cover and push the white valve pin in the center of
the valve to the “DOWN” position. This allows all the air to escape. NOTE: This will be
loud!
Step 2A: For Daily Use With the board facing top side up roll/fold the board from nose
to tail. Remove as much air as possible from the board and then press the white push-
pin in the valve to prevent air from going back into the board. Replace the valve cover
once deflation is complete. Fold fins together as originally packaged.
To Next Page
Loading...