21
Parameter settings
At Set page, user can do binding operation, working frequency mode change, and restore factory
settings. When working mode is Auto, system will work at the least interfered frequency channel
dynamically, when it is Manual, user can manually select the specific frequency to use.
Note:
（
1
）
Baud rate of serial telemetry is hard-coded as 115200 in pre-installed QGC, so baud rate of the
radio link should keep aligned if pre-installed QGC is used.
（
2
）
All the parameters only can be changed when radio link between transmitter and receiver is
established.
At Status page, user can check the real-time status of radio link. Key parameters like LDPC pass/fail,
RSSI, SNR, Serial telemetry receiving/sending bytes, Ethernet receiving/sending rate are listed for user
To Next Page
Loading...