25
7 FAQ
(1) Telemetry connection failure?
A: Check baud rate of FC, radio link and QGC are the same or not, check telemetry cable connection
between air unit and FC, check FC telemetry signal is TTL or not.
(2) Is it possible to install other app in RC?
A: it can. And user can get both telemetry and video in pre-installed QGC.
(3) How to do the bind operation?
A: power on air unit and remote controller, press-and-hold the physical bind button of air unit, and
touch on the software “binding” button of RC tool of controller.
(4) How to switch the camera video and how to switch on the lights?
A: Press button A to switch the camera video image, and press button B to control the lights.
(5) Video not available in QGC?
A: Check camera is correctly connected to air unit’s Ethernet port or not(for example, camera of
192.168.199.86 is connected to Ethernet port of 192.168.199.88 by mistake), check the QGC video
parameter settings
To Previous Page
Loading...