Tajfun Planina EGV 65AHK SG User Manual (English)

Questions and Answers:

C
Charles SinghAug 7, 2025
What to do if Tajfun Planina EGV 65AHK SG Winches do not react to controls?
- C
  Caroline WrightAug 7, 2025
  If your Tajfun Planina Winches aren't responding to controls, it could be due to several reasons. First, ensure the winch drive is engaged by checking the PTO shaft connection; without it, the pump won't function. Also, verify the oil level in the reservoir. Another possibility is a power issue. Check the electrical connection on the tractor, confirm the tractor position lights are on, and inspect the remote control battery. Clean any corroded battery contacts. Finally, the control valve might be malfunctioning. Ensure the system is powered as described above. If the valve is temporarily blocked, try unblocking it by simultaneously pushing the control console buttons and magnet push-caps located in the middle of the magnet surfaces.
T
Trevor GilmoreAug 13, 2025
Why is the pulling power low on my Tajfun Planina Winches?
- C
  christophersantosAug 13, 2025
  If you notice low pulling power in your Tajfun Planina Winches, several factors could be responsible. Check the oil level in the reservoir and add oil if needed, also look for and fix any oil leakages. Another cause may be greasy clutch plates, which can occur due to improper chain drive lubrication. If this is the case, clean or replace the clutch plates. Worn out clutch plates or damaged driving components of the winch can also reduce pulling power, so replace them as necessary.
A
Andrew Ponce Jr.Aug 18, 2025
What to do if the oil pressure is under 145 bar in Tajfun Planina EGV 65AHK SG Winches?
- C
  Christine RodriguezAug 18, 2025
  If the oil pressure is under 145 bar in your Tajfun Planina Winches, check the oil level in the reservoir. If it's low, add oil and also try to identify and seal any oil leakages.