To navigate through setup press the UP and DOWN
arrow keys. To change a setting press the 'ENTER' key.
1. This setting has been disconnected and is not
operational. But can be used for a back light in the
display.
2. ZERO TRACKING.
As a result of temperature changes during a
weighing session, the instrument can
fluctuate from zero. Cattle excrement, etc.
also adds weight. You can continue to zero
the instrument automatically when it registers
weights of 10kg or less.
3. WEIGH MODE
HI – High movement of animal
Lo – Low movement of animal
Std – Standard weighing (Default)
4. CHARGING VOLTAGE
Operating Range 5.8V - 6.3V
5. BATTERY VOLTAGE
7. RECORD
To record a weight into the stats press
“ENTER/RECORD” once. The display will
momentarily flash ‘rEc’ and the weight recorded.
Tal-Tec
7
To Next Page
Loading...