Summer Heat Dump & Additional Ducting
Description
Ducted boxes replace the vented heads that a standard appliance is supplied with.
These allow heat to be distributed to other locations or in the case of a summer heat
dump vented to outside for use during the warmer periods.
Operation
There are numerous different sizes of ducted box available each one is built to order
to suit the individual requirements of the customer but all follow the same principle.
Each ducted box will be fitted with gates to allow the operator control of the air flow.
The gates are opened to allow air flow through that side of the ducted box.
A rough ducting dimension size is listed below for the appliances.
Two Duct Runs 50/50 Split
The above table is an approximate guide.
Consult with the manufacture before adding additional ducting to any Talbott’s
appliance as over or under sizing duct runs can lead to damage to the appliance
and possible danger to safety.
Summer Heat Dump & Vented Heads Distribution Ducting and Summer Heat Dump
Summer Heat Dump
The summer heat dump is exactly the same as a single duct run except rather than
distributing the heat to another location its purpose is to send the heat outside allowing
the operator to dispose of wood waste during the warmer periods when the distribution
of the heat is not required.
To Next Page
Loading...
