Need help?Do you have a question about the Tamiya TB-01 and is the answer not in the manual?
General| Scale | 1/10 |
|---|---|
| Chassis | TB-01 |
| Suspension | Independent Double Wishbone |
| Dampers | Friction |
| Differentials | Bevel Gear |
| Width | 185 mm |
| Height | 140 mm |
| Wheelbase | 257 mm |
| Tire Type | Rubber |
| Body Material | Polycarbonate |
| Motor | 540-type |
| Drive Type | 4WD |
| Weight | Approx. 1400g (depending on body and equipment) |
Details the recommended R/C system for the model.
Specifies the required battery type for the model.
Lists necessary tools for building the model.
Lists recommended paints for the model.
Focuses on tool safety and handling small parts during assembly.
Details the transmitter, receiver, and servos.
Instructions for building the differential.
Steps for assembling the gearbox housing.
Instructions for assembling the rear suspension arms.
Attaching the previously assembled rear arms to the chassis.
Instructions for assembling the rear axle components.
Steps for installing the assembled rear axles.
Mounting the rear damper support.
Instructions for building the front suspension arms.
Steps for assembling the front axle components.
Mounting the front axle assemblies.
Attaching various components to the chassis.
Instructions for building the steering linkage.
Details about the steering rod components.
Finalizing the steering linkage installation.
Verifying proper setup of the R/C system.
Mounting the combined receiver and speed control unit.
Connecting the motor pinion to the drive train.
Installing the propeller shaft.
Mounting the rear gearbox assembly.
Mounting the front gearbox assembly.
Installing the covers for the gearbox.
Mounting the upper chassis frame.
Instructions for building the shock absorbers.
Procedure for adding oil to the shock absorbers.
Installing the rear shock absorbers.
Installing the front shock absorbers.
How to organize and secure the electrical wiring.
Instructions for building the wheels.
Mounting the assembled wheels onto the chassis.
Mounting the front urethane bumper.
Installing the main power source.
Securing the antenna cap.
Cutting and preparing the car body.
Instructions and tips for painting the polycarbonate body.
Applying stickers and markings to the body.
Mounting the side mirrors.
Mounting the finished body onto the chassis.
Using aluminum tape for reinforcement.
Adjusting snap pins for proper fit.
Reinforcing safe practices for operating the RC car.
Step-by-step guide for operating the car.
Tips for improving driving techniques.
Common issues and their solutions.
To Next Page