To Next PageTo Next Page
Need help?Do you have a question about the Tamiya TRF 415 MSX and is the answer not in the manual?
General| Wheelbase | 257mm |
|---|---|
| Suspension | 4-wheel independent double wishbone |
| Drive Type | 4WD |
| Weight | Approx. 1500g (including battery) |
| Motor | 540 Type (Not Included) |
| Battery | 7.2V NiMH (Not Included) |
| Differential | Ball Differential |
| Body | Polycarbonate (Not Included) |
| Required Components | Radio system, motor, battery, charger, body, tires |
| Tires | Rubber Racing Slicks |
Specifies the recommended R/C unit for the model.
Information on selecting and installing the motor and pinion gear.
Details on the required separate type battery and charger.
Guidance on the appropriate size for servos.
Suggestion for a compatible R/C car body.
Lists the essential tools needed for assembly.
Essential safety guidelines for operating the R/C model.
Explanation of the 2-channel R/C system components and their functions.
General advice before starting assembly, including parts check and grease application.
Instructions for preparing the lower deck chassis.
Steps for assembling the rear suspension arms.
Attaching the assembled rear arms to the chassis.
Steps for building the ball differential unit.
Attaching the rear bulkheads to the chassis.
Installing the assembled ball differential into the chassis.
Building the rear universal drive shafts.
Assembling the rear axle components.
Attaching the rear upper arms and installing the rear axles.
Steps for assembling the spur gear mechanism.
Mounting the spur gear assembly onto the chassis.
Steps for building the front suspension arms.
Attaching the assembled front arms to the chassis.
Assembling the steering linkage components.
Building the front one-way differential unit.
Attaching the front stiffener brace.
Building the front universal drive shafts.
Assembling the front axle components.
Assembling the stabilizer bars.
Mounting the front stabilizer.
Mounting the rear stabilizer.
First part of the damper construction process.
Procedure for filling dampers with oil.
Second part of the damper construction process.
Instructions for mounting dampers and setting up damper oil viscosity.
Steps for mounting the motor onto the chassis.
Procedure for checking the radio control system functionality.
Mounting the steering servo.
Installing the receiver and electronic speed controller.
Attaching the upper deck to the chassis.
Steps for assembling the wheels and tires.
Attaching the rear body mount posts.
Attaching the front body mount posts.
Guide for securely installing the running battery pack.
Steps for fitting and securing the car body, including antenna setup.
Adjusting gear ratio and suspension arm reversibility.
Adjusting caster angle and standard settings.
Adjusting toe angle by changing suspension mounts.
Adjusting drive belt tension, tire choice, and ground clearance.
Setting toe angle for steering response and camber for grip.
Step-by-step guide for operating the radio control system.
Instructions on starting, running, and stopping the RC car safely.
Guidance on practicing basic driving maneuvers like ovals and figure-eights.
Identifying and resolving common problems like no movement or loss of control.
Information on part codes, service procedures, and contact details.
Detailed settings for front suspension, dampers, stabilizers, and chassis dynamics.
Detailed settings for rear suspension, dampers, stabilizers, and chassis dynamics.
