EasyManuals Logo

Tanaka HTD-2530PF User Manual

Tanaka HTD-2530PF
15 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
www.tanaka-usa.com 5 custsvc@tanaka-ism.com
Owner’s Manual
T
HT-210/210S/2000/2100/2120/2520, THT-240/2510/2530/2540/262
HTD
-
2520PF/
2522PF/2526PF/2530PF
,HTS
-
2530PF
4. Operating procedures
Fuel (Fig. 2-1)
WARNING!
The hedge trimmer is equipped with a two-stroke engine. Always run the engine on fuel, which is mixed with oil.
Provide good ventilation, when fueling or handling fuel.
Fuel
• Always use branded 89 octane unleaded gasoline.
• Use Tanaka two-cycle oil or a quality two-cycle oil at mixing ratio of 50:1 (Gasoline (A) : Oil (B)).
• Never use multi-grade oil (10 W/30) or waste oil.
• Always mix fuel and oil in a separate clean container.
Always start by filling half the amount of fuel, which is to be used. Then add the whole amount of oil. Mix (shake) the
fuel mixture.
Add the remaining amount of fuel.
Mix (shake) the fuel-mix thoroughly before filling the fuel tank.
Fueling
WARNING!
Always shut off the engine before refueling.
Slowly open the fuel tank (1), when filling up with fuel, so that possible over-pressure disappears.
Tighten the fuel cap carefully, after fueling.
Always move the trimmer at least 3 m (10 ft.) from the fueling area before starting.
Before fueling, clean the tank cap area carefully, to ensure that no dirt falls into the tank.
Make sure that the fuel is well mixed by shaking the container, before fueling.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tanaka HTD-2530PF and is the answer not in the manual?

Tanaka HTD-2530PF Specifications

General IconGeneral
BrandTanaka
ModelHTD-2530PF
CategoryTrimmer
LanguageEnglish

Related product manuals