www.tanaka-usa.com 6 custsvc@tanaka-ism.com
Owner’s Manual
HT-210/210S/2000/2100/2120/2520, THT-240/2510/2530/2540/262
-
-
Starting (Fig. 2-2, 2B)
CAUTION!
Before starting, make sure the cutting attachment does not touch anything.
1. Set ignition switch (1) to the ON position. (Fig. 2-2)
*Push priming bulb (4) several times so that fuel flows through the bulb or return pipe. (if so equipped)(Fig. 2-2C)
2. With the safety lever (2) pressed (if so equipped), pull throttle trigger and push lock button (3) (if so equipped),
then slowly release the throttle trigger first, then the safety lever. This will lock the throttle in the starting position.
3. Set choke lever to CLOSED position (4). (Fig. 2-3)
4. Pull recoil starter briskly, taking care to keep the handle in your grasp and not allowing it to snap back. (Fig.2-4,4B)
5. When you hear the engine want to start, return choke lever to RUN position (open). Then pull recoil starter briskly
again.
NOTE!
If engine does not start, repeat procedures from 2 to 5.
6. After starting engine, pull throttle trigger to release throttle lock. Then allow the engine about 2-3 minutes to warm
up before subjecting it to any load.
To Next Page
Loading...
Need help?
General
