MAN-AT-A1 Manual Aquatop (2019) 4
A1 - Constructional preparations: Top mount
General:
• Level control is necessary to install and use an automatic slatted cover. Provide an
overflow and a refilling system to guarantee the correct level in case of a skimmer
pool.
• Do not place any obstacles in the back or side walls which can interfere with the slats.
For example: skimmer covers, ladders, etc…
• The area where the supports for the roller have to be installed should be horizontal and
strong enough to hold the fixation.
• In the area where the slats go in and out of the pool, the coping stone should not
overlap the pool wall. If necessary cut the coping stone in this particular area.
• Roman ends, rectangular ends and other particular shapes cannot always be rolled up
completely.
Concept:
• Two SS brackets (1 on each side of the pool) support the roller shaft.
• There are different types of supports depending on the type of cover for the roller
shaft.
Options:
To Next Page