TankNet PL-1 User Manual

PL-1 Thermostat User’s Guide
Version 2.0
Firmware Version 2.0
- 2 -
Table of Contents
Introduction................................................ 1
Conventions................................................ 2
Front Panel Layout........................................ 3
Thermostat Modes........................................ 4
Thermostat Mode Programming...................... 5
Set Point (SET 1)......................................... 6
Set Point 2 (SET 2)………………………………………….. 7
Temperature Units........................................ 8
Probe Display............................................... 9
Probe Alarms (P1A and P2A).......................... 10
High Alarm (AL
—
)......................................... 11
Low Alarm (AL
_
)........................................... 12
Brix Entry (Br) ............................................ 13
Pump-over Entry (Po)................................... 14
Pump-over Duration (PoD)............................ 15
Thermostat Configuration Menu (CC).............. 16
Thermostat Differential (Dif)............... 17
Unit Lock (UL)................................... 18
Cooling Probe (CP)………………………………. 19
Heating Probe (HP)........................... 20
Heat Relay (Hr)................................ 21
Heat Mode Disable (Hd)..................... 22
Data Entry Disable (ddE).................... 23
Power-up Delay (Pud)........................ 24
Show “OFF” (SoF)………………………………… 25
Network Installation (service function)............ 26
Wiring - Power, Solenoids & Probe………………….. 27
Wiring - Internal Cable Connections................ 28
Fuses and Service........................................ 29

TankNet PL-1 Specifications

General

Brand	TankNet
Model	PL-1
Category	Thermostat
Language	English

Summary

Thermostat Modes

Thermostat Mode Programming

Set Point (SET 1)

Set Point 2 (SET 2)

Probe Alarms (“P1A" and P2A”)

High Alarm Threshold (“AL˜˜”)

Low Alarm Threshold ("AL_")

Control Configuration ("CC")

Thermostat Differential (“diF”)

Cool Probe ("CP")

Heat Probe ("HP")

Heat Relay ("Hr")

Heat-Modes Disable (“Hd")

Network Service Function

External Wiring

Internal Cable Connections

Fuses and Service