CORDLESS UNIT
www.tanningessentials.co
STEP 6
Once the treatment application is complete, hold the power button
down to turn the system off. Unscrew the retaining nozzle by twisting
it anti-clockwise, remove the adjustable spray nozzle and replace it
with the drying nozzle attachment. To secure the fitment of the dry
nozzle, re-attach the retaining nozzle by twisting clockwise.
STEP 7
Re-power system with airflow set to MIN, be sure not to pull the
trigger as this will release residual solution that may be present
in the system.
STEP 8
Once treatment is complete, and the system is turned off, place it
back on charge.
STEP 5
To begin your application, power on the system by holding down
the power button for 1-2 seconds. Once powered, click the power
button again to increase airflow from min to max. Recommended
setting MIN for drying and MAX for application.
Note: Pull the trigger to start the stroke and release the trigger to
finish the stroke. The system must be moving when the trigger is
pulled.
To Next Page
Loading...