Master Unit
1. System controller/slave switch.
In the “out” position the monitor operates
as a System Controller.
* There can only be one system Controller in a setup.
In the “in” position the monitor operates as a
regular master or a slave unit.
2. RJ45 link connectors for downstream slave units,
remote and PC control.
3. Analogue Inputs.
4. AES/EBU Digital Input
5. Word Clock BNC Sync
6. Power Input 100-240v and Power ON/Off Switch.
Slave/Subwoofer
1. RJ45 Link Connections for downstream slave units, remote and PC control.
2. Power Input 100-240v and power ON/Off Switch.
13
Optional Digital I/0 Card
With this card installed in the
master monitor. Analogue input
slot a 5.1 Digital/ 6 Master setup
becomes an option. Three
AES/EBU connections (6ch) can
then be fed to one master
monitor and distributed
downstream. See the”setups”
section for further information.
1
3
2
4
5
5
1
1
2
To Next Page
Loading...
