Tannoy ACTIVE STUDIO MONITORS - Parameter Categories

31
Parameter Categories
Global Parameters
These parameters apply to the entire system: -
Global parameters stored with presets
• Bass Management
• Mute Status
Global parameters NOT stored with presets
• Ref. Levels
• Analog Input Sensitivity
• Selected Setup
• BNC Sync
Local Parameters
These parameters apply to individual Precision monitors: -
Local parameters stored with presets
• X-Curve
• Parametric EQ setting (set via optional PC-iP
™
)
• LFE Gain (subs)
• LFE Low Pass (subs)
• Rel. Level
Local parameters NOT stored with presets
• Bass and Treble
• Delay
• Lock status (set via optional PC-iP
™
)
• Room position
• Calibration Level
• Tasks
• Phase (Subs)
• Polarity (Subs)
Recall
• Press ENTER and use ARROW keys to select presets
• Press ENTER to recall/load the selected preset
If no user-preset are stored on locations 1 to 4, presets 16 to 19 are loaded instead.
Complete preset list is available on page 52.
Store
• Press ENTER and select storage location using the ARROW keys
• Press ENTER again to store.
Storage location can be 1-15.
Parameter can be locked via the optional PC-iP
™
Installers software. When trying to change values on a locked parameter
the LCD display reads “Locked”.