DEFINITION MANUAL_09
TECHNICAL SPECIFICATIONS
DC8 DC8 Ti DC10 Ti
PERFORMANCE
Recommended amplier power 30 - 175 30 - 200 30 - 250
(watt RMS)
Continuous power handling 87 100 125
(watt RMS) 7.8 Arms
Peak power handling (watt) 350 400 500
Sensitivity (2.83 volt @ 1 m) 88 dB 89 dB 92 dB
Nominal Impedance (ohm) 8 8 8
Frequency response (-6 dB) 42 Hz - 35 kHz 33 Hz - 35 kHz 30 Hz - 35 kHz
Dispersion (degrees conical) 90 90 90
DRIVE UNITS
Dual Concentric high frequency 25 mm (1”) Titanium dome 25 mm (1”) Titanium dome 25 mm (1”) Titanium dome
with Tulip WaveGuide
TM
with Tulip WaveGuide with Tulip WaveGuide
Dual Concentric low frequency 200 mm (8”) treated paper 200 mm (8”) treated paper 250 mm (10”) treated paper
pulp cone with rubber pulp cone with rubber pulp cone with twin roll
surround. surround. impregnated fabric surround.
44 mm (1.75”) edge 44 mm (1.75”) edge 44 mm (1.75”) edge
wound voice coil wound voice coil wound voice coil
Bass Driver - 200 mm (8”) treated paper 250 mm (10”) treated paper
- pulp cone with rubber pulp cone with twin roll
- surround. impregnated fabric surround
- 44 mm (1.75”) edge 44 mm (1.75”) edge
- wound voice coil wound voice coil
Passive Radiator - - -
Magnetic Screening No No No
CROSSOVER
Crossover frequency 1.5 kHz 1.5 kHz 1.5 kHz
Crossover Type
Passive low loss Passive low loss Passive low loss
2nd order LF, 1st order HF 2nd order LF, 1st order HF 2nd order LF, 1st order HF
Deep Crypgenically Treated Deep Crypgenically Treated Deep Crypgenically Treated
CONSTRUCTION
Enclosure type Rear ported Rear ported Rear ported
Volume 19 L (0.67 cu. ft.) 43 L (1.52 cu. ft.) 76 L (2.68 cu. ft.)
Dimensions (H x W x D) 470 x 271 x 260 mm 1081 x 370 x 260 mm 1176 x 434 x 320 mm
excl grille (18.5 x 10.7 x 10.2”) (42.6 x 14.6 x 10.2”) (46.3 x 17.1 x 12.6”)
Weight 10 kg (22.05 lbs) 28.8 kg (63.38 lbs) 43 kg (94.79 lbs)
Finish High gloss black High gloss black High gloss black
High gloss cherry High gloss cherry High gloss cherry
High gloss dark walnut High gloss dark walnut High gloss dark walnut