A mains fuse is provided in the IEC power inlet on the back of this apparatus, which can only be removed with the power cord
unplugged. This must be replaced by a fuse of the same type and rating (see Specications or refer to rear panel).
The wires in the mains lead are coloured in accordance with the following code:
BLUE - NEUTRAL
BROWN - LIVE
As the colours of the wires in the mains cable may not correspond with the coloured markings identifying the terminals in your
plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or
coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or
coloured RED.
Make sure that neither wire is connected to the earth terminal of the three pin plug.
Due to the powerful drive unit magnet, do not place within 1 metre (3 foot) of a cathode ray tube (CRT) television or monitor.
There is no issue with plasma and LCD devices.
This equipment has undergone safety and EMC testing, and complies with the European Low Voltage Directive 73/23/EEC
and Electromagnetic Compatibility Directives 89/336/EEC and 2004/108/EC.
No maintenance of the loudspeaker is necessary.
This equipment has been produced and tested with care and precision. It is built to give rst class service and carries a 2
year warranty on the electronics and 5 years on the drive unit. If the equipment proves to be defective within this period for
any reason other than accident, misuse, unauthorised modication or fair wear and tear, Tannoy will repair any such defect or,
at our option, replace it without charge for parts, labour or return carriage. This warranty is given in addition to the customer’s
statutory rights.
If you suspect a problem with your loudspeaker, please contact your local Tannoy dealer who will be able to advise on
appropriate action. If you require further assistance, then we ask you to deal directly with your local Tannoy distributor.
If you cannot locate your distributor, please contact us directly:
Customer Services, Tannoy Ltd., Rosehall Industrial Estate, Coatbridge, North Lanarkshire, ML5 4TF, Scotland
Telephone: 01236 420199 (National)
+44 1236 420199 (International)
Fax: 01236 428230 (National)
+44 1236 428230 (International)
Email: enquiries@tannoy.com
To Next Page
Loading...
