04_ HTS101 XP MANUAL
ASSEMBLING THE CENTRE & SATELLITE (HTS101) WALL BRACKETS
Fit the wall brackets to the smaller satellite speakers if you wish to wall mount them. (See Fig. 1)
• Locate the appropriate screws and lock washers in the accessory pack - 2 screws for each wall bracket.
• Locate the hex key tool which you will use to tighten the hex socket head screws.
• Each wall mounting bracket has two halves and a long pin which holds the two halves together to act as the hinge.
One half is mounted on the speaker using 2 screws and the other half is mounted on the wall using suitable
screws and wall plugs. It is your responsibility to ensure that the wall and the screw xing method are both strong
enough to support the weight of the satellite speakers. See the specication page for weights.
• Separate each bracket into two halves by removing the long hinge pin.
• Fit one half of the bracket with the large holes to the speakers using the screws and lock washers provided.
The threaded hinge pin hole in the bracket should face the terminals on the back of the speaker.
• Fit the 2 halves of the brackets to the centre speaker with the threaded hinge pin hole in the bracket facing the
terminals on the back of the satellite. This orientation will allow the hinge pins to be tted from either side of the
cabinet when mounting to the wall. Fit the other half of the bracket(s) to the wall using a suitable xing method for
the type of wall material - seek professional advice if unsure.
• Position the satellite or centre speaker (with half the wall bracket(s) tted) against the other half of the wall bracket
already tted to the wall. Line up the brackets so that the long screw pin can be inserted vertically from below the
satellite or horizontally from the sides of the centre speaker and screwed up lightly. The speakers will now swing in
the horizontal plane (vertical plane for the centre) for best aural and visual effect. Tighten the long pin to nish.
• To remove the speakers from the wall to access the wiring terminals, remove the long pin whilst carefully
supporting the weight of the speaker.
• Alternatively, self adhesive feet are provided for shelf mounting.
To Next Page
Loading...
Need help?
General
