Flying Bracket – Each VLS Series loudspeaker
is also supplied with a ying bracket. The
bracket is attached to the top two inserts
(see below) using the supplied M6 screws.
The two bottom inserts can be used as pull
back if required
Pan-Tilt Bracket (optional) – A pan-tilt
bracket is available which allows panning
and tilting for exible orientation along both
horizontal and vertical axes. Detailed installation
instructions are provided with the bracket.
Rigging and safety
procedures
The installation of Tannoy loudspeakers using
the dedicated hardware should carried out only
by fully qualied installers, in accordance with
all the required safety codes and standards
that are applied at the place of installation.
WARNING: As the legal requirements for ying
vary from country to country, please consult
your local safety standards ofce before
installing any product. We also recommend that
you thoroughly check any laws and bylaws prior
to installation. For more detailed information on
rigging hardware and safety procedures, please
consult the full VLS Series Operation Manual.
Outdoor applications
VLS Series loudspeakers are rated IP64 for
resistance to dust and moisture ingress, and
are resistant to both salt spray and UV exposure,
making them suitable for use in most outdoor
applications. Please consult with your Tannoy
dealer before installation in applications with
extreme exposure to adverse environmental
conditions such as prolonged heavy rainfall,
prolonged temperature extremes, etc.
To Next Page
Loading...
Need help?
General
