licensed for the recycling of waste electrical nd electronic equipment (EEE). The mishandling of this type of waste could have a
possible negative impact on the environment and human health due to potentially hazardous substances that are generally
associated with EEE. At the same time, your cooperation in the correct disposal of this product will contribute to the efficient use
of natural resources. For more information about where you can take your waste equipment for recycling, please contact your
local city office or your household waste collection service.
18. Do not install in a confined space, such as a bookcase or similar unit.
19. Do not place naked flame sources, such as lighted candles, on the apparatus.
20. Please keep the environmental aspects of battery disposal in mind. Batteries must be disposed of at a battery collection point.
21. This apparatus may be used in tropical and moderate climates up to 45°C.
LEGAL DISCLAIMER
Music Tribe accepts no liability for any loss which may be suffered by any person who relies either wholly on or in part upon any
description, photograph, or statement contained herein. Technical specifications, appearances, and other information are subject to
change without notice. All trademarks are the property of their respective owners. Midas, Klark Teknik, Lab Gruppen, Lake, Tannoy,
Turbosound, TC Electronic, TC Helicon, Behringer, Bugera, Oberheim, Auratone, Aston Microphones, and Coolaudio are
trademarks or registered trademarks of Music Tribe Global Brands Ltd. © Music Tribe Global Brands Ltd. 2021 All rights reserved.
LIMITED WARRANTY
For the applicable warranty terms and conditions and additional information regarding Music Tribe’s Limited Warranty, please see
complete details online amusictribe.com/warranty
Introduction
The latest addition to Tannoy’s extensive line of column loudspeakers, VLS Series introduces another proprietary Tannoy innovation:
FAST (Focussed Asymmetrical Shaping Technology). By combining transducer technology from the acclaimed QFlex Series with an
innovative new passive crossover design, FAST provides exceptional acoustical benefits, including an asymmetrical vertical
dispersion pattern that gently shapes acoustical coverage toward the lower quadrant of the vertical axis. The VLS 7 and 15 are
EN54-24 certified for use in fire detection and fire alarm systems.
This Quick Start Guide presents only the essential information required to properly unpack, connect and configure a VLS Series
loudspeaker. Please consult the full VLS Series Operation Manual for additional detailed information on low impedance versus
70/100 V operation, complex loudspeaker system configuration, cable types, equalization, power handling, rigging and safety
procedures, and warranty coverage.
Unpacking
Each Tannoy VLS Series loudspeaker is carefully tested and inspected prior to shipment. After unpacking, please inspect for any
exterior physical damage, and save the carton and any relevant packaging materials in case the loudspeaker again requires packing
and shipping. In the event that damage has been sustained in transit, please notify your dealer and the shipping carrier immediately.
Connectors and cabling
VLS Series loudspeakers are connected to the amplifier (or to other loudspeakers in a 70/100 V system or series/parallel
configuration) using a pair of internally paralleled barrier strip connectors.
All VLS Series models can be operated as either a low impedance loudspeaker or within a 70/100 V distributed system. The
operation mode is selectable via a single switch located on the rear of the cabinet (see below).
Operation in low impedance mode often will require the use of larger diameter cables than are needed for a 70/100 V distributed
system. Please consult the full VLS Operation Manual for recommended cable types for various applications.
Switch for Low-Z and transformer tap selection
To Next Page
Loading...
Need help?
General
