09 10
CLEANING AND MAINTENANCE
1. Clean the earbuds and the charging case on a regular basis.
2. Use dry and soft cotton cloth to wipe the unit.
Note: Do not insert anything into the product.
3. Keep away from sharp objects to avoid scratches.
4. Put the unit in a dry and shady place if it is to be idle for a long time.
5. Do not clean the product with detergent or chemicals.
Bluetooth out of
Range / Failed to
pair with your device
/ Disconnected
Note: The Multifunction Touch Control is available only when you are
wearing the earbuds.
Can’t find
“TAOTRONICS
SoundLiberty 80” in
the Bluetooth
device list
The earbuds reconnected with previously
paired device automatically:
• Deactivate the Bluetooth function of
previously paired device or clear
“TAOTRONICS SoundLiberty 80” from
its Bluetooth device list, and then
search again
• Put the device to be connected close to
the earbuds
4
Failed to pair the
earbuds with your
device
• Turn on the device and activate its
Bluetooth function before pairing
• Bring the earbuds into pairing mode
as instructed in the “Pairing” section
5
7
6
No sound in one of
the earbuds in
couple earbuds mode
Place both earbuds back to the charging
case then take them out, they will pair
with each other automatically. If pairing
failed, restore them back to the factory
settings as instructed in the “Clear Pairing
List” section
TROUBLESHOOTING
Successfully paired
with your device
/ Connected
No. Problem Solution
Failed to turn on the
earbuds
Earbuds low battery, please charge them
1
Failed to charge the
earbuds
• Place the earbuds into the charging
case properly
• Make sure the charging case is charged fully
2
Can’t charge the
charging case
Make sure the charging cable is intact
and plugged in properly
3
Failed to use a
single earbud
• As instructed in Single Earbud Mode,
make sure both earbuds are paired with
your device first.
• Then follow the steps to pair the single
(left or right) earbud with your device.
• Once paired, you can freely use the
single (left or right) earbud.