How to Use
1. Cable Connection
1) Plug the 3.5mm audio connector into the AUX interface of your car;
2) Set the audio source of your car audio system to LINE IN or AUX.
▲Note:
y Please make sure your car supports AUX as this car kit only supports AUX audio input;
y In addition to the car charger, you can use another DC 5V power source to supply power to the
TT-BR03.
2. Bluetooth Pairing
Method One
To connect the TT-BR03 with another Bluetooth device, you must first bring it into pairing mode.
1) Ensure the TT-BR03 and your Bluetooth device are in close proximity to each other (within 3 feet);
2) If it’s the first time using this device, the TT-BR03 will automatically enter pairing mode when the
power switch is turned “ON”. If you have previously used the TT-BR03, please press and hold the
MFB for 3 seconds. In both cases, the LED indicator will flash red and blue alternately.
3) Activate Bluetooth function on your device and search for the nearby Bluetooth connection
y For iPhone® : Settings > Bluetooth > On
y For Android™ : Settings > Bluetooth: On > Scan for devices
4) “TaoTronics TT-BR03” should be listed in the search results. Select the name to connect. Once
connected, the LED will be solid blue.
▲Note:
y While bringing the device into pairing mode, the LED will flash blue once; then red once; then will
flash blue and red alternately until paired.
y After successfully pairing, the LED indicator will flash blue once every 10 seconds if there is no
action from your mobile phone; if an action is performed the LED indicator will stay blue.
y If a PIN code is required for pairing, please try “0000” or “8888” (4 zero or 4 eight);
3. Pair Two Devices Simultaneously
The TT-BR03 supports pairing two devices simultaneously. Please note that only one device can
stream audio at a time.
To pair with two devices:
To Next Page
Loading...