Set the Timer
Long press the Power button to set the timer for 30 minutes. The LED
Indicator will blink white when the timer is duly enabled. Long press the
Power button to disable the timer at any time.
Adjust the Light Brightness
Tap and hold the Light Brightness + / - Button to adjust the light brightness.
TROUBLESHOOTING
Hands are wet
LED component failed
The touch
panel is not
responsive
LED failure
Touch the panel with
dry hands
Disconnect power to
restart the lamp
Please contact the
TaoTronics Support Team
Problem Possible Cause Solution
No power supply
The lamp
does not
light up
Correctly plug in the
power adapter
The lamp is not
turned on
Refer to the How to
Use section
EN EN
causing panel failure
Voltage fluctuation
WARRANTY AND SERVICE
In case of any problem, please contact the TaoTronics Customer Care Centre
in your country via the contact information listed in this User Guide.
Bad smell
Power adapter failed
Short circuit
Please contact the
TaoTronics Support Team
Please contact the
TaoTronics Support Team
03 05 07 09 11 13 15 17 19
21 23 25 27 29 31 33 35 37 39
41 43 45 47 49 51 53 55 57 59
61 63 65 67 69 71 73 75 77 79
81 83 85 87 89 91 93 95 97 99
02 04 06 08 10 12 14 16 18
20 22 24 26 28 30 32 34 36 38
40 42 44 46 48 50 52 54 56 58
60 62 64 66 68 70 72 74 76 78
80 82 84 86 88 90 92 94 96 98
To Next Page
Loading...
Need help?
General