EasyManua.ls Logo

TaoTronics TT-SK019 - Troubleshooting; Care and Maintenance

TaoTronics TT-SK019
15 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Note:
·Please make sure no other open Bluetooth® devices are within range, and that the sound
bar is within 3 feet / 1 meter of your device.
·It’s not recommended to pair the sound bar with your TV Bluetooth, it may cause audio delay.
Troubleshooting
Q: Why is the unit not turning on?
A: Please check and make sure the power cord is correctly connected to a power source.
QWhy is there no sound or why is the sound is distorted?
APlease go over the following:
• Check to make sure the audio cables are correctly connected.
Turn up the volume.
• Press the [MUTE] button to switch on the sound.
• Press the [PLAY/PAUSE] button.
• Set the audio output mode on your TV corresponding to the mode setting on the sound bar
Q: Why do the buttons on the sound bar not work?
A: Switch off the sound bar and unplug. Then connect it to a power supply and switch it on again.
Q: Why does the remote control not work?
A: Please go over the following:
• Install 2 AAA 1.5 batteries into the remote.
• Replace the current batteries with new ones.
• Make sure the remote control is pointed to the remote control sensor during use.
• Make sure the remote control is within operating range.
• Switch off the sound bar and disconnect the power. Then reconnect and power on again.
Care and Maintenance
• Keep the sound bar away from extreme heat and humidity. Do not put the product under
direct sunlight or hot areas.
• Do not try to take the product apart. It may cause serious damage.
• Do not drop or knock your sound bar on hard surfaces as it may damage the interior circuits.
• Do not use chemicals or detergents to clean the product.
• Do not scrape the surface with sharp objects.
03/04
DE
Produktabbildung
Vorderseite
Rückseite
Fernbedienung
Display
Power-Taste /
Modus Auswahl
Stummschalten
Optischer Eingang Coaxial-Eingang Stromanschluss RCA AUX Eingang
Lautstärke - Lautstärke +
1. Power-Knopf
2. Stummschalten
3. Lautstärke +
4. Vorheriges Lied
5. Weiter
6. Wiedergabe / Pause
7. Lautstärke -
8. Bluetooth-Modus
9. AUX-Modus
10. Coaxial-Modus
11. Optischer Modus
L
AUXDC18V/2ACOAXIALOPTICAL
R
1
2
3
4
5
6
7
8
9
10
11
BT
AUX
OPT
COAX

Other manuals for TaoTronics TT-SK019

Related product manuals