04/05
Warnung
1. Um das Risiko von Feuer oder Stromschlag zu mindern, sollten Sie dieses
Gerät weder Regen noch Feuchtigkeit aussetzen.
2. Verwenden Sie weder Chemikalien noch Reinigungsmittel, um das
Produkt zu reinigen. Reinigen Sie das Gerät nur mit einem trockenen Tuch.
3. Kratzen Sie nicht mit scharfen Gegenständen über die Oberäche.
4. Blockieren Sie keine Belüftungsöffnungen. Gemäß der Herstellerhinweise
montieren.
5. Halten Sie die Soundbar von extremer Hitze und Feuchtigkeit fern und
setzen Sie sie keiner direkten Sonneneinstrahlung aus.
6. Nicht in die Nähe von Hitzequellen wie Radiatoren, Heizregistern, Öfen etc.
stellen.
7. Achten Sie darauf, dass niemand auf das Kabel tritt und dass es nicht
gequetscht wird, besonders bei Steckern, Gerätesteckdosen und am
Punkt, wo das Kabel aus dem Gerät herauskommt.
8. Trennen Sie das Gerät bei Gewittern und, wenn Sie es lange Zeit nicht
nutzen, vom Strom.
9. Um Stromschlägen vorzubeugen, sollten Sie das Gehäuse (oder die
Rückseite) nicht abnehmen.
10. Im Inneren benden sich keine vom Benutzer zu wartenden Teile. Bitte
überlassen Sie Wartungsarbeiten qualiziertem Service-Personal.
11. Ihre Soundbar darf nicht auf harte Oberächen fallengelassen oder
geschlagen werden, da dies die Schaltkreise im Inneren beschädigen
kann.
DE
Im Lieferumfang enthalten
• 1 x TaoTronics Soundbar (TT-SK023)
• 1 x Fernbedienung
• 1 x RCA zu 3.5mm Audiokabel
• 1 x Optisches Kabel
• 1 x Bedienungsanleitung
• 2 x Wandhalterungsschrauben
Troubleshooting
Q: Why is the unit not turning on?
A: Please check and make sure the power cord is correctly connected to a
power source.
Q: Why is there no sound or why is the sound is distorted?
A: Please go over the following:
• Check to make sure the audio cable is correctly connected.
• Turn up the volume slowly.
• Press the Mute button to switch on the sound.
• Press the Play / Pause button.
• Set the audio output mode on your TV (if applicable) accordingly with
the mode setting on the sound bar.
Q: Why do the buttons on the sound bar not work?
A: Switch off the sound bar and unplug. Then connect it to a power supply
and switch it on again.
Q: Why does the remote control not work?
A: Please go over the following:
• Install 2 AAA 1.5A batteries into the remote.
• Replace the current batteries with new ones.
• Make sure the remote control is pointed to the sound bar during use.
• Make sure the remote control is within operating range.
• Switch off the sound bar and disconnect the power. Then reconnect
and power it on, try again.
Q: Why can't I disconnect the device by pressing the Bluetooth Mode
button?
A: You need to press and hold the Bluetooth Mode button on Remote
Control for 2-3s, or the Mode Selection button on the sound bar for 5-6s to
disconnect a Bluetooth device. The Bluetooth Mode indicator then will
ash when waiting for a reconnection.