P r o T r a x & M a x T r a x S a w T a b l e s
ProTrax and MaxTrax Care and Transportation Instructions
1
Care & Maintenance: Routine care and maintenance
is required to keep your ProTrax and MaxTrax Saw
Table functioning properly. The Lock Block and
Cam Shaft must be oiled periodically with WD-40 or
equivalent to ensure optimal life expectancy. We
recommend all parts be cleaned and oiled weekly
or more frequently if conditions warrant. Be sure to
periodically check all parts for proper alignment and
tighten any hardware as needed.
Handling Instructions: Always latch the ends of
the table in place before lifting. Failure to do so
may damage the table and cause personal injury.
Product made of aluminum alloy, sharp edges can
occur, use caution.
Transportation: When transporting, remove the saw
and the boom from the table. Remove table from the
stand. Lay the table and the boom flat in bed of truck
and secure them to vehicle.
Caution: Always follow general safety rules for saw
tables and read your circular saw safety rules and
operating instructions before use with the ProTrax
Multi-Angle Saw Table. Always use safety goggles
when operating a saw. Always operate on level
ground to avoid tipping. Because of sparks, do not
use near flammable materials. Be aware that a saw
kickback may occur at any time. Saw keeper must be
locked in place before performing cutting operations.
The use of any other accessories not specified in this
manual may create a hazard.
ProTrax shown with optional:
• Snap Stand
™
• Wheel Kit
• Deck Extenders
(circular saw not included)
BOOM
DECK
LOCK BLOCK
CAM SHAFT
DECK
EXTENDER
To Next Page
Loading...