Tapo RV30 User Manual (English)

Questions and Answers:

B
Bailey RiveraJul 28, 2025
Why won't my Tapo RV30 connect to Wi-Fi?
- W
  William AustinJul 28, 2025
  There might be several reasons why your Tapo Vacuum Cleaner isn't connecting to Wi-Fi: * The Wi-Fi signal may be weak, so ensure the vacuum is in an area with good signal strength. * The Wi-Fi connection may be abnormal; try resetting the Wi-Fi and downloading the latest app. * The password may be incorrect, so please double-check it. * The vacuum only supports the 2.4 GHz frequency band, so ensure you're connected to a 2.4 GHz Wi-Fi network.
J
Julie AndersonAug 1, 2025
What to do if my Tapo RV30 is not charging?
- J
  johnsonmichaelAug 1, 2025
  If your Tapo Vacuum Cleaner is not charging, try the following: 1. Remove the robot vacuum and check if the dock's indicator light is on, and ensure both ends of the dock's power adapter are plugged in. 2. Poor contact may be the issue. Clean the spring contacts on the dock and the charging contacts on the robot vacuum.
L
Leslie WagnerAug 5, 2025
Why is my Tapo Vacuum Cleaner scheduled cleaning not working?
- J
  Jessica PerezAug 5, 2025
  If the scheduled cleaning on your Tapo Vacuum Cleaner isn't working, here are a few things to check: 1. Ensure the battery level is above 20%, as scheduled cleaning only works when the battery is sufficiently charged. 2. Make sure that the cleaning is not already in progress when the schedule starts. 3. Verify that Do Not Disturb is not active in the app during the scheduled time. 4. Check that there is internet access for your Wi-Fi network and that the robot vacuum has not restarted.
C
Crystal HortonAug 9, 2025
What to do if my Tapo RV30 has decreased cleaning ability or dust leakage?
- R
  Richard BaileyAug 10, 2025
  If your Tapo Vacuum Cleaner's cleaning ability has decreased, or if it's leaking dust: 1. Check if the dustbin is full and clean it if necessary. 2. Inspect the filter for clogs and clean or replace it. 3. Examine the main brush for any entangled foreign matter and remove it.
Z
zandersonAug 14, 2025
How to fix Tapo RV30 recharge failure?
- J
  John WilliamsAug 14, 2025
  If your Tapo Vacuum Cleaner is failing to recharge, consider the following: 1. Obstacles near the dock can interfere with recharging. Place the dock in an open area. 2. If the robot vacuum is too far from the dock, place it closer and try again. 3. Clean the spring contacts on the dock and the recharge sensor/charging contacts on the robot vacuum.
W
westlisaAug 18, 2025
How to fix Tapo Vacuum Cleaner setup failure?
- C
  Chloe FreemanAug 18, 2025
  To resolve a setup failure with your Tapo Vacuum Cleaner: 1. Ensure the power switch on the left side of the robot vacuum is toggled to “ON”. 2. If the battery level is low, place the robot vacuum on the dock to charge. 3. Check your internet connection and router settings (Allow List or Firewall).

Tapo RV30 Specifications

General

Suction Power	3000Pa
Battery Capacity	5000 mAh
Charging Time	4-5 hours
Filter Type	HEPA Filter
Water Tank Capacity	300 ml
Navigation	LiDAR Navigation
Noise Level	55 dB
Runtime	180 minutes
Features	Multi-Floor Mapping, Virtual Walls, No-Go Zones, Voice Control
Connectivity	Wi-Fi