2
Unpacking Your Water Softener
Please Remember – Only use Tablet or Pellet Salt in Your Softener!
1 Control Valve Cover & Electronic Faceplate
2 Salt Lid
3 Salt Cabinet
4 Water Softener Valve & Motor
5 Resin Cylinder
6 Brine Well and Cover
7 Overflow Connection
8 Drain Connection
Notes
1 Serial Number and Date Code are under the Salt Lid
2 Remove all packaging parts from inside the unit.
3 If you need to remove the valve cover for ease of installation follow
the instructions carefully.
Release the two catches either side of the valve cover and tilt top end
towards you slowly, taking care not to pull off the wire connections.
Please note that the valve cover is connected to the valve motor,
so cannot be removed fully.
8
7
6
3
2
1
5
4
To Next Page
Loading...
