FIT THE INLET AND OUTLET ADAPTOR ELBOWS
Remove the plastic plug from the outlet port on the water softener valve,
if present. Fit the ‘O’ rings to the outer groove of each adaptor elbow.
Push the adaptors into the valve inlet as far as they will go. Lightly lubricate
using the silicone grease provided.
NOTE: Do not use petroleum jelly or oil based lubricants.
Step By Step Guide To Plumbing The Softener (cont)
7
Please Remember – Only use Tablet or Pellet Salt in Your Softener!
Inlet
Outlet
‘O’ Ring
‘O’ Ring
To Next Page
Loading...
