Rev. 08/22
Attaching to Tractor Attaching PTO Shaft
Attention: Because of the possibility of damage to the mower, NEVER:
• Exceed the tractor’s PTO 600 RPM.
• Lift the mower while the drive is engaged, and the drums are rotating.
• Mow while backing up (this will cause machine to fail!)
Resting Position
• The mower in the resting position is completely separated from the tractor’s suspension system. The
mower is repositioned from the transport position to the resting position.
• The following should be done for that purpose:
• With the three-point suspension system, the support of the mower should be lowered and secured with a
cotter.
• Lower the mower and rest it on the stump jumper discs and the support.
• Disengage the engine and pull out the key from the ignition and set the brakes.
• Disconnect the pivotal end of the tractor’s upper connector from the suspension frame yoke.Take down the
tractor’s push rod ball joint from the suspension frame pins.
TECHNICAL MAINTENANCE OF THE MOWER
Changing the Blades
• To install or disassemble the blades on the operating disc, a special blade changing tool should be used,
which is included in the basic equipment of the mower.
Operation
Danger: Due to the sharp edges of the blades, protective gloves should be used in disassembling
the blades.
To Next Page
Loading...
