What to do if Tar River Lawn Mower belts are sliding?
If the belts on your Tar River Lawn Mower are sliding, it could be due to several reasons. The belts may not be tightened sufficiently, they might be wet or worn out, or they could be of different lengths. To resolve this, check and adjust the tension of the belts. Avoid mowing in the rain. Replace the belts with new sets, ensuring you use one brand with belts of the same dimensions.
Why Tar River Lawn Mower has a bad cut and clogs?
A bad cut and clogging in your Tar River Lawn Mower's cutting system is often caused by dull or damaged blades. Replace dull or damaged blades with new sets. Blades dull on one side should be installed on the disc with the opposite direction of rotations.
How to fix increased vibrations of Tar River BDR-185?
Increased vibrations in your Tar River Lawn Mower are often due to unevenly worn out or damaged elements of the cutting system. Replace the worn out elements with a whole new set.
What to do if Tar River BDR-185 Lawn Mower cutting system tilts to the back?
If the cutting system of your Tar River Lawn Mower tilts backward during normal operation, it's likely due to the fuse. The fuse spring might be lightly tightened or damaged. Check and adjust the tension of the spring; replace it if it is damaged.
Explains safety alert symbols and signal words like DANGER, WARNING, CAUTION.
General rules and precautions for safe operation and maintenance.
Pre-operational checks and safety steps before starting.
Safety guidelines to follow while the mower is in operation.
Safety precautions for transporting the mower on roads.
Guidelines for operating the drum mower safely and effectively.
General| Brand | Tar River |
|---|---|
| Model | BDR-185 |
| Category | Lawn Mower |
| Language | English |
To Next Page
