EasyManua.ls Logo

Targa DP-5100 - Page 31

Targa DP-5100
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
31
Reference
General:
If the DVD Regional code fits not with player code together,
change of regional code - Visit our homepage www.targa-online.com
A firmware-upgrade is possible.
Please take a look at the service sites of www.targa-online.com
Attention:
You lose the warranty, if you use a firmware of other sources.
Symptom
• The remote
control does not
work properly.
• The DVD player
does not start
playback.
• No skip function
possible.
• No or wrong
language in
subtitle.
•
Only one camera
angle available.
• No card found.
•
No picture.
• Buttons do not
work.
•
Parental function
is blocking the
player.
Possible Cause
• The remote control is not
pointed at DVD Player
• The remote control is too far
from the DVD Player
• The batteries in the remote
control are empty
• The batteries in the remote
control are not in the right
position
• An unplayable disc is inserted.
• The rating level is set.
• Dirty/Scratched DVD/CD
• DVD-Audio (24bit/96Kbit) or
SAC-CD.
• DIVX DVD (Version 6.x or
greater)
• DVD-RW is not finalized
• DVD/VCD/CD have not
chapter/index or blocked
• Subtitle setup is not right
• DVD has only one camera angle
• Memory card is not in the right
slot
• File that is not palyable was
stored.
•
Forgot parental password
Correction
• Point the remote control to the
remote sensor on DVD-Player
• Operate the remote control
closer to the DVD player
• Replace the batteries
• Replace the batteries to the right
+/- signs
• Insert a playable disc. (Check the
disc type, colour system, and
regional code.)
• Cancel the rating function or
change the rating level.
• Clean DVD/CD
• This DVD's are not supported by
this player
• Check on TARGA Homepage for
possible Firmware Upgrade
• Finalize DVD-RW on PC or
DVD-Recorder
• Some medias have only some or
no chapters/index, no solution.
• Change in subtitle menu
• Most DVD's have only one angle,
no solution
•
Input card in the right Memory
Card Slot
• Use after saving playable files.
• Switch the power switch on the
back side off, wait 5 seconds and
then on
• Use the Master Password
210499
(See “Lock Menu” on page 16.)
Heading
Remote
control
DVD/VCD
/CD-
Playback
DVD/VCD-
Playback
DVD-
Playback
Memory
card
playback
Operation

Table of Contents