Tarmo TAR010 - Starter Handle

Safety presence grip bar
Hold in the safety presence grip bar against the
handle.
Starter handle
The dead man’s grip must be pressed in when
starting the engine.
Misuse of the starter handle ca damage the
starter. DO NOT twist the starter cord around
your hand.
Pull out the handle slowly until the gears mesh.
Then give a sharp pull on the starter handle.
DO NOT pull out the starter cord completely
and DO NOT let go of the starter handle when
extended.
Throttle
Keep the throttle at idle. When the throttle is
increased, the cutting wheel will begin rotating.
ATTENTION
BEFORE OPERATING THE STUMP MACHINE,
CHECK THE SCREW M8X50 CREWS TIGHTLY
ON THE CENTRIFUGAL CLUTCH.