WARNING
NEVER LEAVE OPERATING POSITION WHEN CUTTING BLADE IS ROTATING! KEEP EVERYONE
AND ALL ANIMALS AWAY WHEN CUTTING BLADE IS ROTATING.
Procedure for cutting a stump
Stage 1
1. Place stump machine into position with cutting blade near the front-top edge of stump.
2. Set brake to lock position.
3. Set throttle to (START ) DISENGAGE position.
4. Start engine.
5. Allow engine to warm up at idle for two minutes.
6. Move throttle up to the ENGAGE position (this will engage the cutting blade rotation).
7. Swing the cutting blade to one side, then lower it approximately 1/2″to 1″into the front-
top corner of the stump. Swing the cutting blade back and forth, lowering the cutting
blade approximately 1/2″to 1″before each sweep, until you have removed the front
portion of the stump to ground level.
NOTICE
BEFORE OPERATING THE STUMP MACHINE, REVIEW
“MACHINE CONTROL” AND “OTHER MACHINE
COMPONENTS” PRESENTED EARLIER IN THE
“OPERATION” SECTION, FOR A REFRESHER ON THE
FUNCTION AND USE IF EACH CONTROL AND
COMPONENT.
OPERATING ON HILLS
BE VERY CAREFUL WHEN OPERATING THE STUMP
GRINDER ON HILLS BECAUSE THE MACHINE CAN
SLIP OR MOVE UNEXPECTEDLY.
NEVER USE THE MACHINE ON GRADES OF 10
PERCENT OR STEEPER.
TRANSPORT
SECURE THE MACHINE WITH TENSIONING BELTS,
CHAINS OR OTHER APPROVED MATERIALS.
To Next Page
Loading...