8. Raise cutting blade until center of cutting blade is just above top of stump.
9. With the cutting blade off to one side, advance the machine horizontally by releasing and
resetting the brake. Advance the machine forward to engage the cutting blade into the
stump so that when swept across the stump it will remove 1/2″to 1″of stump with each
sweep.
10. Sweep the cutting blade across the stump, cutting away 1/2″to 1″of stump.
11. Advance cutting blade 1/2″to 1″, and sweep across stump in opposite direction.
12. Continue sweeping cutting blade left and right across stump, advancing it before each
sweep, cutting 1/2″to 1″depth of stump with each sweep.
13. Continue cutting until top level of stump is all removed, making sure not to cut stump
deeper than ground level during this first stage.
14. Turn throttle to the (START) DISENGAGE position, wait ten seconds for blade to stop
rotating then release brake and retract machine from stump.
15. Pull machine away from stump, and rake chips away from stump.
Stage 2
16. Place stump machine into position with cutting blade near the front-top edge of the
stump.
17. Set brake to lock position.
18. Move throttle up to the ENGAGE position.
19. Complete cutting stump by repeating step 12 again and again until entire stump is cut to
desired depth.
20. Stop the machine
WARNING
A ROTATING CUTTING BLADE IS VERY
DANGEROUS! STAY AT THE OPERATING
POSITION AND BE SURE THAT THE BLADE
COMES TO A COMPLETE STOP BEFORE
DOING ANYTHING ELSE.
TIPS:
TO MAKE OPERATING EASIER, CUT STUMP
TO SAME LEVEL AS GROUND.
To Next Page
Loading...