Tascam MP-GT1 - Introduction; Placement and Use Precautions

TASCAM MP-GT1 3
Precautions for placement and use
The MP-GT1 may be used in most areas, but to maintain
top performance, and prolong operating life, observe the
following notes, precautions and environmental condi-
tions:
Avoid exposing it to extremes of temperature and
humidity and avoid mechanical shocks and vibration.
Keep the unit away from strong magnetic fields (TV
sets, computer monitors, large electric motors, etc.).
The nominal temperature should be between 0°C and
40°C (32°F and 104°F).
Relative humidity should be 30 to 80 percent.
•
•
•
•
As the unit may become hot during operation, always
leave sufficient space above the unit for ventilation.
Do not install this unit in a confined space such as a
bookcase, and do not put anything on top of the unit.
Avoid installing this unit on top of any heat-generat-
ing electrical device such as a power amplifier.
Make sure that the unit is mounted in a level position
for correct operation.
The voltage supplied to the unit should match the
voltage as printed on the rear panel. If you are in any
doubt regarding this matter, consult an electrician.
•
•
•
•
Manual conventions
In this manual, we use the following conventions:
Controls and keys on the MP-GT1 are written like
this: MENU.
Messages shown on the display are written like this:
Are you sure? .
•
•
If a fixed onscreen indicator (i.e. one which cannot
change) is shown, it is written like this: VSA.
We use the term “key” to describe the push-button
controls on the MP-GT1.
•
•
Supplied accessories
In addition to this manual, the following accessories are
supplied.
Quick Start Guide .......................................................1
Mini-B USB cable ......................................................1
An insertion sheet .......................................................1
Warranty card .............................................................1
•
•
•
•
Please contact the store where you purchased this unit
if any of these accessories are missing or have been
damaged during transportation.
NOTE
We recommend that you keep the original box and
packing materials for transportation of this unit.
Thank you very much for purchasing the TASCAM
MP-GT1 Portable Memory Guitar Trainer. Please read
this Owner’s Manual carefully before using the unit in
order to maximize your use of all its features. We hope
that you will enjoy using this trainer for many years to
come.
The MP-GT1 is a flash memory (1 GB) music player
that has been optimized for practicing guitar. If you
run into a phrase on a recording that is too difficult
for you to learn by ear at ordinary speed, you can play
and loop the music at a slower speed to study the part.
Furthermore, the dedicated guitar input allows you to
use the unit’s built-in effects as you play along with the
music. Using a computer, you can also transfer music as
MP3s easily from audio CDs and other sources to the
MP-GT1.
Beware of condensation
If the unit is moved from a cold to a warm place,
or used after a sudden temperature change, there
is a danger of condensation; vapor in the air could
condense on the internal mechanism, making correct
operation impossible. To prevent this, or if this occurs,
let the player sit for one or two hours at the new room
temperature before using.
1 – Introduction