Task Force TF2500 - Trouble Shooting Guide

AWSC = Authorized Warranty Service Center
PROBLEM CAUSE CORRECTION
Engine will
not start (see
Engine Manual
for further
engine
troubleshoot-
ing)
.leuFddA.leufoN
Pressure builds up after two
pulls on the recoil starter or
after initial use.
Squeeze gun trigger to relieve
pressure.
Choke lever in the "No Choke"
position.
Move choke to the "Choke"
position.
Spark plug wire not attached. Attach spark plug wire.
Engine switch in OFF
position.
Place engine switch in ON posi-
tion.
Choke lever in the "Choke"
position on a "hot" engine
or an engine that has been
exposed to thermal heat for a
long period of time.
Move choke to the "No Choke"
position.
No or low
pressure
(initial use)
Spray wand not in high pres-
sure.
See How to Use Spray Wand
instructions in the Operation
Section.
Low water supply. Water supply must be at least
5 GPM @ 20 psi.
Leak at high pressure hose
fitting.
Repair leak. Apply sealant tape
if necessary.
Nozzle obstructed. See Nozzle Cleaning instruc-
tions in the Maintenance sec-
tion.
Water filter screen clogged. Remove and clean filter.
TROUBLE SHOOTING GUIDE
33